|NIST Home | NIST Museum Home | Museum Exhibits | Photo Gallery | Contact|
The Collapse of the Silver Bridge:
|next >> Why Did Eyebar Break?|
On December 15, 1967 at about 5PM the traffic signal at one end of the Silver Bridge turned red. The rush hour traffic, together with the Christmas shopping traffic, completely occupied the main span of the bridge connecting Point Pleasant, West Virginia with Kanauga, Ohio. Suddenly a loud cracking sound was heard and one of the main towers began to twist and fall.
In less than a minute, all three spans of the bridge collapsed into the icy Ohio River, carrying with them all the cars, trucks, and people.
Forty-six died and many more were injured.
1. Scale model reproduction of the actual bridge from the physical exhibit in the
What Caused the Bridge to Fall?
The Silver Bridge (so named because it was painted silver with aluminum paint) was an eyebar suspension bridge. Instead of the cables that are so familiar on modern bridges, the highway was suspended by eyebar chains.
An eyebar is a long steel plate having large circular ends with an "eye" or hole through which a pin is used to connect to other eyebars (to make a chain) or to other parts of the bridge. The pins are held in place with bolted cap plates.
A unique feature of the Silver Bridge was that the eyebar suspension chains also were part of the top chord of the stiffening trusses and only one eyebar per suspension point was used.
This design results in light weight, cost-efficient construction, but depends on high strength steel eyebars. Only two other bridges were built with this efficient design: the St. Mary's, West Virginia bridge and a bridge in Florianopolis, Brazil. The high strength steel eyebars required only one-half of its ultimate strength to support the fully loaded bridge. So, why did the Silver Bridge fail?
Inspection of the Wreckage It was found that an eyebar had broken through the eye. The nature of fracture - a flat, brittle fracture on one side and a fully flexible bending hinge point failure on the other - indicated that this eyebar failed under normal services loads and initiated the collapse.
2. An arrow points to the eye at the right of the tower (see picture 1. above) where
The U. S. Army Corps of Engineers recovered both pieces of the eyebar (as well as most of the bridge) from the river and brought them to NBS for analysis. NBS was selected for this important phase of the investigation because of its competence in metallurgy and long experience in failure analysis.
Stressed to the Ultimate Visually, the two fractures on opposite sides of the broken eye (see picture above) are quite different. On one side, the fracture was straight across, indicative of a brittle fracture below the normal service load and caused by a flaw. There is no thinning or bending associated with this part of the fracture. It broke in a brittle fashion like a piece of glass. Furthermore, this part of the eyebar shows no stretching or bending that would have occurred in steel that was stressed to its ultimate strength.
On the other side, is a plastic bending hinge that indicates that this side was stressed to its ultimate strength and beyond. This must have occurred after the brittle fracture on the other side shifted all the load it was carrying to this side, essentially doubling the stress on this side, resulting in the visible, extensive deformation before failing.
Suspension Chain Unpins, Tower Rotates Once this eyebar failed, the pin fell out, unpinning this part of the suspension chain. The adjacent tower was subjected to an asymmetrical loading that caused it to rotate and allow the western span to twist in a northerly direction. This span crashed down on the western shore, folding over on top of the falling cars and trucks. Loaded by the whole weight of the center span, which had now become unsupported on its western end, the east tower fell westward into the river along with the center span. Finally, the west tower collapsed toward Pt. Pleasant and into the Ohio River, completing the destruction of the Silver Bridge.
Date Created: July 8, 2009